📱+351 244 555 060 | ✉vidromecanica@vidromecanica.com

Annealing Lehr

Excellent performances and results on glass annealing lehrs. You can find our lehrs in operation at internationally renowned glass producers.


Batch Plants

Vidromecanica is responsible for services and equipment for the preparation of the batch and external/internal cullet glass collection system.


Belt Cleaning Brush

This brush equipment is used to clean the lehr belt before glass article charging. It is recommended when under belt coating is installed, and for…


Cold-End Coating Systems

Vidromecanica designs over-belt and under-belt cold end coating equipments for the glass industry. Lehr belt width up to 6,0 meters. This equipment…


Cullet Crushers

This equipment is conceived to crush the glass not only in the plants (hot or cold glass), but of the outside as well. It allows a constant…


Dosing Systems

It makes the surface treatment of articles in the cold zone by spraying with a low concentration of polyethylene wax emulsions, creating a surface…


Glass Recycling Plants

Recycled glass process systems are used for removing harmful contaminants such as dirt, stones, plastics, metal, ceramics and paper from external…


Moulds Pre-Heating Kilns

The Mould pre-heating kiln is available with one, two or three doors, corresponding to one, two or three trolleys.Doors and trolleys motion can be, according…


Oleic Acid Treatment

It applies oleic acid cold-end coating to glass containers, creating a thin surface layer which allows the containers to slip easily during handling.


Scraper Conveyors

After receiving the rejected hot cullet and gobs in a water bath, this scraper conveyor carries the cooled glass to the stock area.


Stackers – Lehr Loaders

Displacement is made through a sphere shaft with sliding upon guides with skate-type bearings. Electro-mechanical control or by electronic…



Our stirrers systems are designed to the dispersal of cat-scratch cord; improvement to chemical or thermal homogeneity and the mixing of colours…


Thermal Shock Test Machine

The thermal shock machine is used to determine the resistance of hollow glass containers to sudden changes in temperature less than 100°C…

Annealing Lehrs
Decorating Lehrs
Tempering Lines
Hot and Cold-end Coatings
Cullet Processing
Vidromecanica Engineering
Contact us